Error AP POWER

[lisavbedt]

l getting error on ap is flashing red green and blue and my switch is cisco small business SF300-POE And no wifi this ap is covert to me newest version sill flashing red green blue

[marce1000]

     - That means that the AP is getting insufficient power , 

 M.

[lisavbedt]

How do l fix it ? Do l need switch with poe+??

[marce1000]

 - Start by looking at the datasheet of the particular AP model and look for powering requirements, then compare to switch capabilities , or find other switch model (e.g.) ; or use power adapter 

 M.

[Rich R]

What model of AP?

What version of software?

Do you have CDP or LLDP enabled on the switch port?

[lisavbedt]

• no l think not and ap is update to newest version ME

[Rich R]

• no l think not
  CDP or LLDP is required for POE+ to work correctly.
• and ap is update to newest version ME
  So you confirm it is running 8.10.190.0?

[lisavbedt]

Good Reading l orderd new switch Cisco with poe+ when arrived l hope its works? 

[lisavbedt]

Yes ap running newest version

[lisavbedt]

Al model is airap2802i-b-k9

[Rich R · Accepted solution]

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-2800-series-access-points/datasheet-c78-736497.html#Productspecifications

Input power requirements

●  802.3at PoE+, Cisco Universal PoE (Cisco UPOE ®) ●  802.3at power injector (AIR-PWRINJ6=)

Whether or not your SF300 switch supports 802.3at depends on the exact model number of the switch. Refer to the Power over Ethernet (PoE) table at https://www.cisco.com/c/en/us/products/collateral/switches/small-business-smart-switches/data_sheet_c78-610061.html to see whether your switch supports it or not.  If not then you will need a power injector or switch which does support 802.3at (POE+).

[lisavbedt]

problem is sloved its was switch new switch is arrived with poe+ and worked normal en showing my wifi thanks everyone

[Rich R]

Glad to hear you worked it out.