| |
CURWB1 |
CURWB2 |
| Antenna |
IW-ANT-OMH-2567-N |
IW-ANT-OMH-2567-N |
| PID |
IW9167EH |
IW9167EH |
| IP ADDR |
192.168.1.10 |
192.168.1.11 |
| MODE |
MESH END |
MESH POINT |
AP1# show dot11Radio 1 config
Interface: enabled
Mode: fixed infrastructure
Frequency: 5180 MHz
Channel: 36
Channel width: 80 MHz
Antenna number: 4
TX power level: auto
TX power: 20 dBm
Antenna gain: unselected
Maximum tx mcs: 11
High-efficiency: enabled
Maximum tx nss: 4
RTS protection: disabled
guard-interval: 800 ns
ampdu max length: 255
distance: 1000 m
The ampdu Tx
priority 0: enabled
priority 1: enabled
priority 2: enabled
priority 3: enabled
priority 4: enabled
priority 5: enabled
priority 6: disabled
priority 7: disabled
Enhanced Distributed Channel Access (EDCA) configuration
vo: aifs=1 cw_min=2 cw_max=3 txop=15
vi: aifs=1 cw_min=3 cw_max=4 txop=31
be: aifs=3 cw_min=4 cw_max=6 txop=31
bk: aifs=7 cw_min=3 cw_max=4 txop=0
Passphrase: CiscoURWB
AES encryption: enabled
AES key-control: disabled
Key rotation: disabled
Key rotation timeout: 0(second)
We put two CURWB APs on a single desk and connected them with MESH.
Then we connected a PC to the DC injector and measured the network with PC to PC and iperf.
But we are not satisfied with the speed.
I need some advice to improve the speed.
