Hi, my 2 881 in a site, running IOS c880data-universalk9-mz.150-1.M4.binsuddenly lost their routing for the fe4(WAN)!!It happened once to the 1st one and then to the other (no connection between them).The problem is that wan interface, although it wa...
Hi. I know this question has been asked several times but I haven't found any thread that really offered the most optimal solution. I used to manage an active/active ASA setup connected to two routers running hsrp which in turn is connected to two I...
Hi,I have some question in injecting an MPLS over our network. We have this requirement that will interconnect our client's private network to our network via MPLS. Our existing topology is physically layered (see topology below). What we want is to ...
Hello,One of our Routers 7204 rebooted unexpectedly. I try to access Output interpreter but is not working. Can someone help me to find the reason why this happened. The output from our router is the following:WAN-ROUTER#sh versionCisco IOS Software,...
High performance with integrated services• The Cisco 2900 Series enables deployment in high speed WAN environments with concurrent services enabled up to 75 Mbps.• A multigigabit fabric (MGF) enables high-bandwidth module-to-module communication with...
Hi all. I was just wondering if anyone know which routers support this QoS protocol? From my reading, any firmware from 12.2 should support it, but does it also depend on the router? A representative told me only the 3900 series router or the 7200...
Hello.Im running IOS version 12.4(20)Ive been reading that some versions of the IOS will have a noticeable affect on network performance if log-input command is used on an access list.Is this true for my version of IOS?I understand logging is going t...
Hi,I'm trying to setup port forwarding to a citrix server but,it seems not to be working, can someone please tel me what I'm doing wrongAs you can see I'm using dyndns an I have verified its working by pinging the host ...Building configuration...
C...
Hi AllI have two ASa firewallsone firewall subnet 192.168.2.0 /24 has EZ VPN set up onit talking to the other firewall 192.168.5.0/24of the firewall 192.168.5.0 has a DMZ subnet 172.16.10.0/24User VPN into the firewall of 192.168.2.0 the VPN range 10...
We have two locations with connections to two different ISPs which provides redundancy/failover should either connection go down. This works fine but I would also like to implement some kind of load balancing to shift some of the load from ISP A to I...
Due to historical reasons we currently have an OSPF network with multiple areas.Since we only have 4 (collapsed core layer-3) catalyst switches left, I want to migrate to a single area for simplicity.- Is it possible to migrate without disruption? be...
hi,I have a branch location with two links and I need one link to be primary for some routes and the other link to be primamry for others. Does anyone know of a way to manipulate specific routes using OSPF, much like what an offset list would do for ...
