Hi folks I kindly requesting help to fully setup an Air-Lap1242G-E-K9 & converting to autonomous mode.I found this device in a box of stuff being thrown out and would like to see whether I can get it up and running for my home use.The device looks un...
My wlc9800 needs to send log to a server (splunk), warning level, the server administrator wants to know how many megabytes of information will be sent to the server, I have searched for documentation but I cannot find that information. Does anyone h...
hi i have Wireless controller 5502 a3nd AP 3802 and config Locally Significant Certificates with Microsoft CA and present CA and device but on AP show error
Has anyone here successfully added new MIBs to LibreNMS for monitoring of access points? If yes, could you porvide a detailed walkthrough of what you did. Currently adding WLC9800 to LibreNMS detects the SSIDs, but does not detect the APs connected...
I have a few AP2802e that i would like to use in a mesh configuration . I was wondering if i could put the APs further appart by using external antennas with extensions. Would 2 antennas from different APs connect to each other for the mesh or do tth...
Hi,Per the title, I've got an issue with 5Ghz clients that have good signal strength because they are sat almost underneath the AP (1832 APs) yet but struggling to get more than 1Mbps throughput. I can see the channel utilisation is over 50% but zer...
I've a virtual machine (Windows 7) on my MacBook running on VMWare Fusion 6 running in bridge mode and can't get an IP address from my DHCP server. NAT mode in VMWare is working, but not an option.I've tracked down the problem with Wireshark to the D...
I've been seeing "fixed versions" in bug notes recently including versions 17.9.5a and 17.9.5b for 9800 WLCs. I do not see those versions on the software download page. Are these escalation builds, upcoming public releases, etc.? Here are all the 980...
1. In cisco wlc 9800, is it possible to set the Rmi redudency port with different vlan then the WLC management vlan?2. I understood that there are should be two management vlan addresses for each one of the controller and only the address of the acti...
I have a main LAN (192.168.0.0/), and I'm creating an isolated subnet (10.10.0.0/) that directly connects to the internet gateway (firewall). Routing between the two is handled by the firewall, and security is the sole, uncompromising priority. This ...
Hi wireless colleagues, After multiple tries with the configurations I have managed to enable MFA on the C9800 for admin access through CLI by using TACACS+. The integration is done via ISE with NPS as Proxy RADIUS to Entra ID MFA Service in the clou...
I have an issue with getting to the internet once authenticated via our Cisco ISE guest portal. Access to the internet does not work for at least 3 to 5 minutes before everything just kicks in and it works without any network intervention. We have C...
Cisco Catalyst 9800-80 Wireless Controller version is 17.9.4a. I check compability matrix and no problem to registring ap. But ap logs Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5). and i check AP join statistics on C9800-...
when i speed test my connection using wifi thorutpot sppeed stuck in 20Mbps but when i using LAN my speedtest get 80Mbps , i using cisco embended wireless controller, my AP series 9115AXI-F