Created by: Matt K. on 16-10-2008 08:13:04 PM How do I configure # when I define an Inline DTMF Local Hotlink in CVP Studio. When I use #, it does not work and I keep getting nomach but when I use * it works fine. CVP Studio does not let me to configure it as '#' either
Thanks, Matt
Subject: Re: Local Hotlink does not work with # (dtmf-#) Replied by: Janine Graves on 16-10-2008 08:37:41 PM
is preconfigured as the termchar.
So it is always stripped off by the gateway.
You will have to disable the termchar to receive # into the app
You set the vxml property named termchar to z (or anything other than a dtmf touchtone). This can be done in the root document using project properties or temporarily in any vouce element in the Settings tab.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: