Hi all,
I have been searching, but can't seem to find an answer to a problem I have.
I have loaded the 5 interface OVA file on an ESXi host and followed the setup guide, but I am unable to access the UWM. Running virl_setup, I have the primary interface set to eth0 and it is set to a static IP.
While running through the troubleshooting steps listed here (T-Shoot: UWM admin page unavailable; error: "unable to connect" - 31607 - The Cisco Learning Network) I noticed when I run grep -E '^internalnet_' /etc/virl.ini the internalnet_port is set to eth4 instead of eth0.
Even after rerunning virl_setup and selecting eth0 as the primary interface, internalnet_port is stuck at eth4.
How can I update the ports so I am able to access UWM?
I am running virl.5i.1.3.296.esxi.ova