About delr

delr · 06-12-2019

Hello CSC Problem DescriptionI have a C2811 GW with c2800nm-adventerprisek9-mz.151-4.M12a.bin and one VIC2-4FXO connected to a legacy 4xSIMs GSM GW for outbound calls to cel numbers. Each GSM GW FXS port is a SIM card, and each one is connected to a ...

delr · 08-08-2017

Hello CSC, I want to know if there is a way to check CUCM LDAP sync status , also if there is a way to setup notifications (like for DRS on RTMT) when LDAP scheduled syncs end (to get evidence that syncs were done) Regards.

delr · 11-16-2016

Hello, I want to change some phones (7942,9971) on CUCM to register to a CME 8.6 for tests. However. following the common procedure on the phones of: Activate Alternate TFTP to the CME TFTP IPs , delete the trust list on the phones, and waiting that ...

delr · 07-08-2016

Hello, reading this document (https://developer.cisco.com/site/sxml/learn/getting-started/risport/index.gsp#service-activation) I find that the link for Cluster service activation recommendations.is broken, and I need to know how to activate the SX...

delr · 08-28-2015

Good Afternoon, I just want to know if there is a way to extract information of RTP streams when streams end and reoriginate there via MTP or TRP resources, even if its posible to enable RTCP in CUCM to take statistics of those streams at CUCM side, ...

delr · 11-17-2016

Hello, today I could register the 7942 but only after register it first on CME as ephone , otherwise it went to register to CUCM again. What I dont understand yet is why the CIPC persisted on registration process and didn't ended register on CUCM, me...

delr · 11-16-2016

Hello, I just achieve the registration of CIPC on CME. In this case I saw that, even I have not configured the CIPC as ephone yet, it still persisted on registering state after I deleted the trust list and changed the TFTP addresses (as expected) I'...

delr · 11-16-2016

Hello Jaime Thats exactly what Im doing, set the tftp address on the phones to cme. In this moment Im configuring CIPC to see what happens.. Regards.

delr · 08-30-2015

Hello, thanks for your answer. I was wondering in another method for extract RTP streams info besides CMRs or CUCM Traces, because CUCM CMR werent as accurate in our operation, and CUCM traces could be intensive in busy-hours.When you mention that we...

delr · 08-29-2015

Ok, I understood, thats what I want to know, the five-tuple . I was thinking that could be important, as we have issues with CUCM CMRs that are reporting bad MOS's of calls around 2.0 or 3.0 , but even if I took EPCs for those calls and I didnt perci...

Member Since	‎02-10-2014 06:04 AM
Date Last Visited	‎06-19-2019 12:35 AM
Posts	37
Total Helpful Votes Received	10

User Statistics

User Activity

Config FXO failover (after call is routed via an" UP" fxo port and returns error tone)

CUCM LDAP sync status or notifications

Cannot change Cisco Phones to CME (even with Trust List deleted)

Cluster service activation recommendations link is broken

Extract RTP/RTCP information from CUCM when streams end and reoriginate there

Hello, today I could register

Hello, I just achieve the

Hello Jaime

Hello, thanks for your answer

Ok, I understood, thats what