I just installed a pair of Nexus 7 k's as our network core. Our default route sends traffic out to an ASA 5545 (10.60.10.30) which uses WCCP to redirect traffic to Websense for web filtering. As part of a Security ELA we signed with Cisco, we are g...
Good morning,I'm relatively new to ISE, so please bear with me. I work in a hospital where we have 1 WLAN dedicated to wireless medical devices (wireless x-ray units) which authenticate to a Cisco 5508 WLC using WPA2-PSK. The WLAN is mapped to VLAN 7...
I'm hoping someone can help me. I work in a health care environment and we currently have a single SSID for medical devices. The SSID uses WPA2-PSK (can't use 802.1x) and is mapped to one vlan. We are adding a large number of new medical devices (...
Hi everyone,
I'm relatively new to ISE, so please forgive my ignorance.
I currently have a small ISE deployment with one 3315 acting as the PAN and MNT. I also have 1 VM in the PSN mode.
In a deployment scenario like this, what is the correct u...
I purchased a 50 pack of SSL VPN licenses for an ASA 5520 a couple of years back. Since then, our Internet circuit has become bogged down and I want to use an ASA 5510 on another circuit as our VPN head-end device. Is there a way for me to transfer...
I'm using Nexus 7706 with software 7.3(3)D1(1).
Here is the config that I used:
IP access list PBR-ACL 10 permit ip 10.60.240.50 255.255.255.255 any 20 permit ip 10.60.240.62 255.255.255.255 any 30 permit ip 10.60.240.68 255.255.255.2...
That didn't work. I applied the following and all traffic on vlan 701 went through 10.60.10.21. The route-map only specifies that 3 hosts are supposed to go through that gateway while the rest of the traffic should go through the default gateway of...