About Kobus Raath

Kobus Raath · 08-12-2019

Hi I have a fairly new installation at a client running in Multi-POD. They are running version 4.1 but since we started to configure and migrate servers we get exceptionally slow responses from APIC. In many cases we receive response errors on both ...

Kobus Raath · 06-26-2019

Hi, I have new Multi-Pod deployment and have an issue with the BGP peering between the spine nodes. Looking at all the spine nodes they all peer with each other except for spine 1022. No one peers with it and the peers remain idle. I cannot seem to...

Kobus Raath · 09-06-2017

HiI did read one of the previous posts where EM do not discover wired endpoints. I did look at the articles and suggestions posted and verified the environment my controller is installed in.I have a slightly different issue here. This is a multi vr...

Kobus Raath · 12-14-2016

Hi, I am having some issues writing a basic python script to configure access switches in mass. The process I am trying to follow is – Connect the switches to the lab network, issue IP address from a DHCP server and use auto config to load a base c...

Kobus Raath · 02-11-2015

Hi Community I am testing (trying) the POAP functionality in the nexus product range but seem to run into some issues. I have a N7009, DHCP, TFTP and FTP connected to a management network. I copied a quite elaborate script from the software downloa...

Kobus Raath · 08-16-2015

Hi chapsI manage to sort out the md5 check.The easiest way is to modify your script file as needed and not change the md5 in the dock. Have the nexus boot and try to load the file. It will report an error that the file could not be validated and wi...

Kobus Raath · 01-14-2015

It looks like is a storage problem. We had an issue that the storage array in our lab (old eol kit) overheated and crashed. Since the rebuild it is visible on the network but does not seem to present luns to any (not just mine) connected servers. ...

Kobus Raath · 01-12-2015

Thanks WalterI’ll check the lun masking. If this is the issue and gets sorted, will this resolve the fcoe boot problem?

Kobus Raath · 01-12-2015

HiTo answer the questions please see comments below. Is UCS running in FC End Host Mode (NPV)Yes, the UCS is running in End Host mode.Is MDS configured for NPIVYes, the MDS is configured for NPIVDo you see the vHBA doing a flogi (Initiator pwwn)Yes, ...

Kobus Raath · 04-02-2012

HiThanks for the reply.The network is somewhat complex. It was inherited with bandwidth optimisers installed off-path. Some firewalls were added and later two VRFs are used to connect four different site profiles to the HO.As soon as I receive traffi...

Member Since	‎11-05-2010 04:45 AM
Date Last Visited	‎02-04-2021 06:03 AM
Posts	14

User Statistics

User Activity

SLOW !! response from APIC

ACI Multi-Pod BGP Peer idle

APIC not discovering some hosts

python to configure switches

POAP failure

Hi chapsI manage to sort out

It looks like is a storage

Thanks WalterI’ll check the

HiTo answer the questions

PBR fails with "set tag" statement.