Dear all
I have a CME (Cisco 4331,Version 16.09.02, CME version 12.3) installation and I am facing the following issue:
CME has a 4 FXO NIM with 3 PSTN lines on it, which works fairly well.
However, when the customer forwards the calls to his mobil...
Hello all
Is there a way to use a trunk port of a switch to connect to a BE4000 appliance
or the connection is exclusively access?
I want to connect a SG250 switch to a BE4000 appliance and it seems that
there is no way to activate the second Gigab...
Dear All Recently we have migrated our company's voice gateway from 2911 to 4331 ISR. After dealing withthe new configuration parameters regarding the PVDMs and their position on the router (NIM card or motherboard) depending on the task required, we...
Hello Everyone
I have been facing the following issue with CUCM and UCCX. I have a H.323 gateway attached to a CUCM v10.5 in which
a UCCX server (v 10.5) is connected with CTI ports and NOT with SIP Trunk. This UCCX server runs an IVR script, accept...
Hello All The solution to the problem was to add the ^ wildcard in front of every rule voice translation-rule 2rule 1 /1031/ /350/rule 2 /^\(31[0-6]\)/ /\1/rule 3 /^\(32[0-5]\)/ /\1/rule 4 /^\(33[0-5]\)/ /\1/rule 5 /^\(34[8-9]\)/ /\1/rule 6 /^\(36[0-...
Hello Thank you both for the help.The incoming rules are used in order to route calls to the AA/IVR when a DID number is used that does not correspond to an internal extension. I have reloaded the gateway several times but it does no seem to be fixi...
Hello Abhay I have removed the 301 dial-peer, reconfigure it, add a new one with an exact match and the DID for the 333 worked OK. Then I removed the dial-peer added (for the exact match)and the 333 DID continue to work! However the 331 DID still doe...
