Dear Everyone
I have the problem about CPA detecting on my outbound CCX. My call flow is
CUCM-----(SIP)----->Voice Gateway----(FXO)---->PBX--------->Fax
(Integrate with CCX)
I upload list to CCX outbound (Progressive) a...
Dear Team I just changed from Cisco router 1841 to Cisco router 4321 but the problem is computer that use to found each other cannot see each other anymore. Every configuration was dump into the new router. So the question is what is the secu...
Hello Everyone Maybe this is another stupid question that you have found before, but I need really help from you.I am goin to repace the router 1841 (advance enterprise IOS version 12.4) 4321 with Cisco ISR 1921 (Universal IOS version 15.4). T...
Hi Team
I cannot type command "auto qos ...." on Cisco Catalyst Switch 2960X software version = (C2960X-UNIVERSALK9-M), Version 15.2(2)E4, RELEASE SOFTWARE (fc2). When I try to enter command "auto qos ...". It show invalid command. Thank...
Hey everybody
I have some problem that I have never found before. I have an FXO on router with MGCP config from CUCM. I can call out to outside via this FXO port but cannot get inbound call. I try to set Attendant DN to my phone but it rang...
May I know what is the different between command in mark 1 / mark 2 and command in mark 4 / mark 5 ? Cause from my perspective it's pretty much the same to me.
I just faced this problem. The way I fixed this thing is change the password. At first I use "123456" after I changed it to "P@ssw0rd". It can continue to integrate with CUCM. Not sure it can work with your system, but not difficult to try. Good Luck...
Hi Julio The ping or tracert from client to domain Controller is work and correct. Actually They are all in the same subnet. I'm trying to add this command "ip forward-protocol udp nameserver ip forward-prot...