We will setup a iwan test enviroment with a apic-em (1.5).What is the requirement for a test hub site?Is it possible to create a hub site with isr4321?From the releasenotes i understand that just branch site is supported for this hardware.Is this a r...

Hello,we have a fax-machine connected directly to a bri port on a cisco3825 gw.To the pstn we have a e1 pri.pstn <--E1-- cisco3825 <--BRI-- FAXSometimes when we send a fax out to the pstn the receiver just gets a blank page but we see a sending succe...

Hi,we have a cisco 3825 with cme 7.0.On the router is a e1 and some fxs ports installed. Now we have some trouble with a fax.Networkclock is fine, no slips!card type e1 0 0network-clock-participate wic 0 network-clock-select 1 E1 0/0/0voice service v...

I cant realise more than two simultaneous internet dialin.I have a cisco 2821 and three dsl lines.There are three ethernet interfaces and three dialer interfaces configured. Every dialer works fine but I cant connect more than two dialer at a time.It...

Why change a port under normal conditions the status?Aug 25 08:58:11: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/43, changed state to downAug 25 08:58:12: %LINK-3-UPDOWN: Interface FastEthernet0/43, changed state to upAug 25 08:58:...