C9200-48p model from 16.12.2 version to the recommended version, 16.12.3a version, after upgrading,NM-4X module is not recognized.If you check on the equipment, there is no NM-4X inventory information in show inventory information, even if you check ...

n3k Set poap on initial build In question, you entered skip.I want to set it back to yes and set it to normal setup.I am wondering if it is possible to change the poap setting to Yes again when the device is already booted and configured with skip. I...

Whether WLC QOS settings are applied Applying the QOS settings on the WLC will determine whether it applies to each user, whether it is applied as an SSID,I would like to know if other standards apply. As a result, I would like to know what standards...

Currently, the SW is a LAN LITE model and only supports single host modeUsing single-host mode,If it is connected as shown below   SW -> (single-host mode setting, mab, dot1x authentication setting)   |   |IP Phone -> (mab authentication, specific vl...