Hi,This also applies to netconf.When router has ACL with ACE like permit tcp xxxx xxxx establish its not shown when doing get.ACE with permit tcp xxxx xxxx ack or other flag is shown when doing get.Checked with IOS-XE release 16.9.Any help appreciate...

Hi, I am testing the csr1000v with openstack. I have noticed that after power outage the router either boot into grub (esc not showing anything) or booting with new image. Have tested with two different X86 hardware and killo/liberty with disk write ...

Hi, I have tested with several x86 systems csr1000v running on top of openstack, and almost every time that I plug out power cord the router boots into grub. I have disabled disk write cache but did not help. This is not happening with other vnfs. An...

HiFrom the below link below it mentioned that "Round-trip latency must not exceed 300 milliseconds (ms) between the AP and the controller. If the 300 milliseconds round-trip latency cannot be achieved, configure the AP to perform local authentication...