Application Centric Infrastructure

Hi Everyone,   We're in the middle of a OpenStack pilot project and are still at the discovery and exploration phase of how OpenStack and ACI work together. So far we've achieved basic integration and functionality via the GBP model to get instances ...

what's best practice for subnets in BD? should we have one subnet per BD? if I've multiple EGP tied to one BD then is broadcast limited to BD to EPGs?   what's best practice for Application profile and EPGs? should I've all EPGs in one application pr...

Hello,   We are working on bring up multi-pod connenctivity between 2 pods and we experience the issue with connectivity. The issue is between the spine and N7K F3 connectivity. F3 line card interface is configured as Layer 3(routed) and resource is ...

what's best naming convention for EPG, BD, AAEP etc?   what's best practice for AAEP and domain? should we have all interfaces in fabric tied to same AAEP?

Dears,   Is there any known software defect (bug) that may cause failure on one of the control plane processes (COOP,IS-IS,MP-BGP)?   Best Regards, Mohammad Taamneh

anyone knows the CLI to check leaf nodes LPM-GST and LPM-LST?   I tried the following command but the output doesn't make too much sense to me.   module-1# show platform internal ns lpm globalGST EGRESS-------Printing for v4:tcam_anchor for Index: 0s...

is there a good ACI design guide that I can use to get customer requirements and determine design for tenants, epg, bd, l2out, l3out etc? please refer me to one. Thanks!

Is it possible to upgrade an existing 9300EX to a 9300FX??

Hi everybody,   A customer that I have build ACI Multi-Pod for have just noticed that they can't pass any packets with a payload higher than 1430 bytes between the pods.    The IPN nodes are Nexus 77K which have MTU 9000 configured on the Spine facin...

We have several F5 clusters running on VMware.  We are considering using a single EPG/BD for all the different HA interfaces.  So cluster1 (2 nodes) could use IPs like 1.1.1.1/30 1.1.1.2/30, cluster2 (2 nodes) could use 1.1.1.5/30 1.1.1.6/30 etc ... ...