Hello!
I'm going through Cisco DevNet Labs and at the moment I'm on this step https://developer.cisco.com/learning/tracks/containers/containers-mgmt/containers-deploy-to-k8s/step/1
Here is point:
Powershell on Windows 10
scp developer@198.18.133.48:"'/home/developer/.kube/config'" $HOME\.kube\config
But if I will execute this command, I will get error message "protocol error: filename does not match request"
Why? It is mistake inside Lab? Or should I run something before executing?
Thank you,
Best regards,
Roman
