How to enable device tracking on 2960-x switch?

[dgombovic]

What is the right way to enable device tracking on 2960-x switch in order to see all connected devices on APIC-EM controller?

After many tries it still won't show any of the connected devices.

Thank you in advance!

[yawming]

Are you using APIC-EM version 1.1.1.34  ?

It would be really helpful if you can get APIC-EM RCA log and the below cli output form 2960

Show ip device tracking all

Show cdp neighbours

Show cdp neighbours detail

Show lldp neigbours

Show lldp neighbours detail

Show ip arp

Show mac address table

Show running config from that device.

[dgombovic]

Thank You for your time, it looks like upgrade of APIC-EM from version 1.1.1.38 to 1.1.2.15 solved this issue.

#sh ip device tracking all

Global IP Device Tracking for clients = Enabled

Global IP Device Tracking Probe Count = 10

Global IP Device Tracking Probe Interval = 30

Global IP Device Tracking Probe Delay Interval = 0

-----------------------------------------------------------------------------------------------

  IP Address    MAC Address   Vlan  Interface           Probe-Timeout      State    Source

-----------------------------------------------------------------------------------------------

10.145.220.99   44d3.ca58.e343 2    GigabitEthernet1/0/4   30              ACTIVE   ARP

10.145.220.98   44d3.ca25.1da0 2    GigabitEthernet1/0/2   30              ACTIVE   ARP

10.145.220.4    2047.47ae.2b6c 10   GigabitEthernet1/0/3   30              ACTIVE   ARP

10.145.220.3    2047.47ae.29f1 10   GigabitEthernet1/0/1   30              ACTIVE   ARP

Total number interfaces enabled: 4

Enabled interfaces:

  Gi1/0/1, Gi1/0/2, Gi1/0/3, Gi1/0/4