VLAN Routing issues

[meziani-tarek25]

Hello I have some trouble with figuring out a solution to make it work for my networkI have a cat 6500 I have interface vlan 60 with network/24 and I need to bind the same network with an other routed physical interface . In short I need to route the same network on the 6500 Switch via two different sources ( interface vlan )and (routed interface , because this one is bundled with an other switch of datacentre via etherchanel and work through encapsulation dot1q and IP address) But I could not give 2 adresses for the previews interfaces from the same network there will be an overlap .Please help me Thank you

[MHM Cisco World]

Router or SW not accepting two interfaces with same subnet. 

MHM

[meziani-tarek25]

Even with using bridge group?

[MHM Cisco World]

the Bridge group will bridge two L2 interface and the only IP you need is for BVI which represent subnet for both interface. 

MHM

[stevewillls8282]

Have you considered using secondary IP addresses on the Fsginspections interfaces to avoid overlap? Alternatively, subnetting might provide a solution to route the same network via different interfaces.