06-12-2012 03:00 AM - edited 03-01-2019 05:35 PM
Hi all,
I'm currently configure IPv6 neflow.
Also I'm confused how to configure the different command options.
What is the difference between the commands:
Router(config)#ipv6 flow-export destination x.x.x.x.
and
Router(config-flow-cache)#export destination x.x.x.x
Also I noticed there are the following command options :
What is the difference from the timeout-rate command under _template_ and _options_?
Router(config)#ipv6 flow-export template ?
options Specify the template option
refresh-rate Specify the number of export packets before template is resent
timeout-rate Specify the time before template is resent
Router(config)#ipv6 flow-export template op
Router(config)#ipv6 flow-export template options ?
export-stats Specify the template option export statistics
refresh-rate Specify the number of export packets before the options are
resent
timeout-rate Specify the time before the options are resent
Thanks
Udo
06-18-2012 07:16 AM
Hi Udo,
Visit the following link to find steps to configure IPv6 NetFlow epxort on your Cisco Device:
http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-netflow.html
Thanks
Praveen Kumar
06-21-2012 08:12 AM
That document points to a netflow implementation that was removed in 12.4(20)T according to its Table 1, so it's no longer very helpful for a growing number of admins.
I'm currently failing to understand whether (and on what devices) IPv6 netflow is supported in the 15.1M train, and if it is, how to configure it via Flexible Netflow.
-jml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide