04-25-2017 10:02 PM
Hey there, assume most devices are profiled. For the remaining Unknown endpoints (which were not able to be profiled) how can I perform an NMAP scan on them in order to profile them?
Thanks
DJ
Solved! Go to Solution.
04-26-2017 02:59 AM
By default, ISE automatically triggers NMAP scan for Unknown endpoints once IP address learned, assuming probe is enabled. If wish to rescan, then can use Manual Scan option from the Profiler Workcenter (newer versions), or from the Probe config screen in older releases.
Craig
04-26-2017 02:59 AM
By default, ISE automatically triggers NMAP scan for Unknown endpoints once IP address learned, assuming probe is enabled. If wish to rescan, then can use Manual Scan option from the Profiler Workcenter (newer versions), or from the Probe config screen in older releases.
Craig
04-26-2017 06:43 PM
Thanks Craig, I assume the 'trigger' for this default behavior depends on whether the NMAP checkbox below is enabled? If it isn't, then the default NMAP scan is not done?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide