ASA 9.6 cli not back after enter to firepower module - ASA 5545

[mahadeer md ismail]

When I connect to the sfr module console from the console of the ASA, what is the exit keystroke to return me back to the ASA console? After going thru the initial wizard to assign an ip to the module, I can exit and that returns me to the sfr login prompt, but I need to exit all the way out back to the ASA console.

This issue keeps annoying me when doing initial setups, and I end up having to do a hard reload on the box to get out.

Tried below one but no luck

ctrl+shift+6 then x

>>

Cisco FirePOWER Services Boot Image 6.2.0

TDCIPSLAN02 login: admin

Password:

TDCIPSLAN02-boot>

TDCIPSLAN02-boot>X
>>
Plz do the needful.

[Dennis Perto · Accepted solution]

I am having the same issues that you are seing. 

I only have these issues when I use "session sfr console" instead of just using "session sfr". 

The console part is unfortunately needed in recovery mode (boot image).

[mahadeer md ismail]

Yes, it is correct.

After both image and pkg installation this got fixed and i am using only session sfr to access this module.

Thanks