ASA PIM-SSM doesn't pass through

[sasha]

Hi. Config guide says ASA should pass PIM-SSM through when it's not LHR. Are there any commands to enable that? I see packets from source to 232.x.y.z in capture on the incoming interface (outside), but not on the outgoing (inside). ASA version is 9.13. Multocast routing is enabled, static route toward source is added. Thanks.

[Harold Ritter]

Hi @sasha ,

"multicast-routing" is the only command you should need. Do you have a pim neighbor on the egress interface?

What do the "show pim topology" and "show pim neighbor" tell you?

Regards,