ASAv50 Display failover state difference CLI with ASDM

[jewfcb001]

We deploy ASAv50 version 9.12 but I found  ASAv50 display failover state difference CLI with ASDM.

CLI Display : Active/Active

ASDM        : Active/Standby

Please suggest me . 

[Pulkit Saxena]

Can you share the "show version" from ASA ?

-
Pulkit

[t_one_cisco]

Hi Pulkit
ASAv Version 9.12(3)9

[Cristian Matei]

Hi,

    Can you post the following output from both ASA's? "show version", "show failover", "show failover state".

Regards,

Cristian Matei.

[Sheraz.Salim]

what is the ASDM version you on.

make sure you on ASDM version 7.13.1

[jimholla]

I don't think that ASAv should be running in active/active mode. What are you running the ASAv on? VMware, KVM, Azure?

[Sheraz.Salim]

agree ASAv does not support active/active.

[jewfcb001]

Hi Sheraz 

ASAv Version 9.12(3)9

ASDM Version : 7.12(2)14 

I not install new asdm I use default asdm in default image on ASAv . 

[Pulkit Saxena]

I don't think this is an ASDM issue as it is showing correct output, now from CLI perspective.
If you are seeing "active/active" in "show version" output, you can ignore that, it is brought from the ASA code.
However if you are seeing "active/active" in "show failover" output, let us know and share the complete "show failover" output.
-
Pulkit

[Sheraz.Salim]

@Pulkit Saxena I agree its not the ASDM issue. I was curious to know what version is on. in regards to ASA cli showing Active/Active could be a cosmetic bug. unless show failover show the same thing even though active/active (multi-context) is not supported in virtual appliance of asav.