Network Security

Cannot get Cisco ASA 5505 to pass VPN traffic

Hi, I am having some trouble getting my Cisco ASA to pass VPN traffic from the Cisco ASA to a DrayTek 2860. The tunnel is up and traffic from the DryaTek 2860 reaches the Cisco ASA but not vice versa. I have checked NAT rules and from what I can see...

ASA, tunnels, and hairpinning

Hi, I am about to replace two Linux "open-VPN" machines with two ASA FWs. In one site the setup is straightforward (one outside interface, and one inside). But on the remote end hairpinning is required. The Linux was connected to the same LAN as the ...

Cisco PIX 501 Firewall Version 6.3(5)

Hi, I was able to come across with an old Cisco PIX 501, the device is up and running however, due to changes in network admins, people in the company was no longer able to store the enable password. I am connecting thru console and so far here's wh...

Forward traffic from Router 800 series

Hello this is firs time I participate in this great Group .. How to Forward traffic from Router 800 series on Specific port to access the network remotelyusing firewall SSL VPN client to site

utm integration with cisco asa 5510

hello everyone; We have at the level of our structure cisco equipment: firewall asa 5510 and 6509. our network includes around 4000 Ethernet jacks in addition to severel wifi access points.We would like to incorporate a utm into our networks for feat...

Resolved! Cisco WSA Virtual 45-day demo license limitations?

Hello all, I have downloaded the Cisco WSA virtual image coeus-9-1-2-022-S000V.qcow2 and have installed the 45-day demo license. I would like to ask about something that I noticed because I can't make the WSA work: I have a PC with IP 10.0.1.10/24 a...

Resolved! Old patches

Hellow! Can i remove old updates from SFR module in ASDM? Take a look at the picture: or all of them must be on disk ?

SSL interception Good or bad ?

Hello, what features can I get by using SSL interception and on the other hand what is the bugs that I can hit or what is the bad side of using SSL interception ?

reseting PIX to facotry defaults without knowing enable password

is it possible to reset to factory default a Cisco PIX 515E without knowing enable password?

Juniper SRX to Cisco ASA Firewall Migration

Hello, I would like to know some features in Cisco ASA as compared to Juniper SRX: Following are the Juniper Configuration need to migrate into Cisco ASA. I am not getting in Cisco ASA,How to Migrate. 1. HA Configuration : Example: set groups no...

Resolved! do i require 2 Licences for AMP for 2 x ASA with Firepower HA pair ?

Hi I am installing 2 x ASA 5525-x with firepower in Active/standby mode. i received - 1 x PAK for FMC - 1 x PAK for protection (IPS & AMP) - 2 x PAK for control i added these licences in FMC. after that i added 1st ASA into FMC and assigned Prot...

SSH to ASA 5500 into privileged exec mode without "enable"

Is there a way to configure a ASA 5500 firewall so that when i access the firewall via SSH, my user is in privileged exec mode immediately after i have entered the login credentials? So no need to enter "enable" anymore. I know how to do that with a ...

Stable Cisco ASA Version

Hi All, Currently we are running 9.5.3.9 on ASA in our environment, but 9.5 release is in End of SW Maintenance now. So can someone tell me what is the stable version in 9.6 or 9.7 release. We are experiencing many issue in 9.5.3.9 so wanna be upgra...