10-13-2015 06:14 PM - edited 03-11-2019 11:44 PM
Hi,
I would like to know if there is a diagnostic tool for ASA to check the equipment health.
Is there a migration tool to convert ACL from 8.2 to 8.3. I know there is for NAT but not sure for ACL.
Regards
Abhradeep
Solved! Go to Solution.
10-13-2015 06:27 PM
Hi Abhradeep,
For continuous equipment health check,yYou need to use some network management software like Solarwinds, Cacti etc.
Migration tool- try https://fwm.cisco.com
ACL changes post 8.3: use real addresses (Internal server IP address) than public IPs.
hth
MS
10-14-2015 04:29 AM
Hi,
You need to save your running config into flash (disk0) in that format. Copy run disk0:/xyz.cfg. Then copy that .cfg to your pc via tftp and upload.
Hth
MS
10-13-2015 06:27 PM
Hi Abhradeep,
For continuous equipment health check,yYou need to use some network management software like Solarwinds, Cacti etc.
Migration tool- try https://fwm.cisco.com
ACL changes post 8.3: use real addresses (Internal server IP address) than public IPs.
hth
MS
10-13-2015 08:21 PM
Hi just one more question. What is this system.cfg its asking for i am not getting it when i download the entire files.
Regards
Abhradeep
10-14-2015 04:29 AM
Hi,
You need to save your running config into flash (disk0) in that format. Copy run disk0:/xyz.cfg. Then copy that .cfg to your pc via tftp and upload.
Hth
MS
10-14-2015 06:26 PM
oh thanks didnt know it was the running config.
i downloaded it via asdm thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide