How to get to know Cisco FTD 2130 throughput

[CiscoJane]

Hello all,

I would like to know how to calculate current throughput value at FTD 2130. What sort of information need to calculate it.? Thanks for any response to solve it. 

[balaji.bandi]

Datasheet provide you what kind of throughput FTD can offer that model :

https://www.cisco.com/c/en/us/products/collateral/security/firepower-2100-series/datasheet-c78-742473.html

Depends on what you looking to do ? you can monitor in and out interfaces using NMS check what kind of traffic transit via FTD.

also some check you can do by following document  - if you have FMC and you can use dashboards.

https://www.cisco.com/c/en/us/td/docs/security/firepower/70/configuration/guide/fpmc-config-guide-v70/dashboards.html#ID-2206-000002e6

[CiscoJane]

Thanks @balaji.bandi , we do not have any monitor system. Can i calculate current through put overall by check cli "show traffic?". Can you please share any method to calculate? 

[balaji.bandi]

i would setup a some kind of NMS so you get average value over time see how much utilisation on the ports.

some command show currect information, does not give you peak information.

[Marvin Rhoads]

Are you using FMC? If so, just look at the health monitor and there you can see device interface statistics over time.

[Marvin Rhoads]

In addition to the datasheet mentioned by @balaji.bandi , remember that datasheet numbers are aggregate throughput. So don't expect that number to show up when you run speedtest from behind a firewall.