Other Network Architecture Subjects

On the normal interface we can use default 75% of the interface bandwidth for CBWFQ or LLQ to classified bandwidth for each application. And we can change default the maximum reserved bandwidth 75% by using the command " max-reserved-bandwidth". But ...

What is the maximum number of subinterfaces that can be configured on the ws-x4232-L3 blade in a cat4000 chasis?

I am having problems with VoIP over MLPPP over FrameRelay, and hopefully someone can explain any bugs? or things I've misunderstood as I explain, or major problems in the config... The end aim is to use this with ATM+Serial routers.Two Cisco 2600's b...

Hi,I am wondering whether there is any known issue about multicast with compression. We have recently conducted experimental implementation of simple "ip pim dense-mode" with "compress stac" and observed intermittent loss of packets in between a mult...

Hello,I have the following situation:Internet | |Cisco 826 WAN IP XXX.XXX.XXX.XXX LAN IP 192.8.100.1 | |Mail server IP 192.8.100.3I have the following Nat configuration:ip nat pool buiten XXX.XXX.XXX.XXX XXX.XXX.XXX...

I've got customers dialing up to our AS5200 for internet access. They get IP addresses just fine and can browse the Internet. I've got one customer that needs a static IP address when he dials into our router. What is the easiest way to do this?He...

CW2K has been setup to receive traps from Cisco kit and to forward them on to our Tivoli netview system. The netview is expecting a different community string to the ones that CW2K is forwarding. Can CW2K change the community string of the traps it i...

Recently purchased a cisco 827 router, i have connected into the box using a serial connection and configured a class C address which i can ping and connect to from another network point.Unfortunatley i am unable to connect to the web configure inter...

HI,All Could you help me confirm the problem? if a cisco7206 regarded as PPPoA terminator and send customers's information to related radius server. Whether a session will first login in cisco7206, if there is no related authentication ability in...

is it possible for a router say 2600 series to based its routing decision on the incoming ports used? eg. 1 if the incoming traffic is smtp/pop3, route it to mail server with ip address X on the LAN 2. And if the incoming traffic is http, route it to...

Dear M. Expert, i have built a samll network (10 ) router interconnect with ther Synch. interfaces. Each router have a an asynchronus equipement at is Aux. port.The main router need to contact each ofthe equipement connect t...

Hi y'allI'm trying to figure out the differences between the 827 and 827H. So far I understand the 827H has 4 10baseT ports, and comes standard with 32mb DRAM instead of 16mb. What else? Does the 827H come standard with IP/FW?ThanksJohn

Does the 'ip helper-address' parameter apply only to the primary IP address on an Ethernet interface? Is it possible to have IP addresses assigned dynamically to the secondary IP range?

On Cisco 7609,can NAM module WS-X6380-NAM with SW ver 2.1 monitor traffic on OSM-4GE-WAN module ?

Hi,I know that theoretically it is possible to install everything on one machine. On the other, there are recommendations that certain parts of the software should not be installed on the same system. E.g. one had better install RTM on a machine diff...