04-09-2024 09:19 AM
Is there a way on a layer 3 device with multiple IP addresses on it to determine what the logging source-interface is set to? I need to go through and verify settings. Besides just going and running the command on everything I was hoping there was a way to see what the source-interface is already set to.
04-09-2024 09:23 AM - edited 04-09-2024 10:10 AM
MHM
04-09-2024 09:24 AM
I did find it. If the command has been ran to specify a logging source-interface it shows up in the show run.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide