Enable PVLAN edge on SG500 switch

[djolenole]

Hi all,

I want to enable PVLAN edge feature on our Layer 2 CISCO SG 500 switches. 

Is command switchport protected-port enough to do that?

I would apply that command to range of ports.

[Bogdan Nita · Accepted solution]

Hi djolenole,

The necessary configuration to enable Private Vlan Edge (protected ports) is switchport protected-port on interface config.

You probably will have to configure 2 interfaces , because the way it works is by blocking L2 traffic between 2 protected ports. Traffic between protected-port and non protected-port is allowed.

HTH

Bogdan

[djolenole]

Thank you Bogdan!