Routing

Hello, Has anyone seen any announcement for EOL/EOS for the Cisco1941/9k router. Can someone point me to a site or document?

I have a ISP, an SG300 Cisco Switch. How to configure this router to receive internet from isp to my SG300 switch?

I have a pair of L3 Core switches (Nexus 7K) where my server farm switches are connected (L2 Switches) I want to replace  these L3 Core switches with new Nexus series. L3 Core switches are defined for Routing (OSPF), HSRP, VPc. I have to do non distr...

SIR, I HAV TO CHANGE THE ALREADY CONFIGURED IPs in cisco router 1905 pls help satish 9416360314 

I have two C3850 switches stacked in a closet and I cannot get anything to come up on the second switch in the stack. I believe it is a firmware mismatch. I have downloaded Putty and it does not see COM4?

I have  2 routers, two firewalls, and 2 core switches, and 6 L2 switches I have these ip subnets 10.76.0.x for management 10.53.140.x servers vlan 33 10.53.141.x shop vlan 34 10.53.142.x wireless vlan 35 192.168.0.x guest wireless vlan 999 vlan 20 ...

I'm deploying a small site WAAS and the topology is a WAAS 474 (4.1.1 code) on a flat subnet - the device off the subnet is a PIX 151 running 8.0(4) code. The ASA terminates and IPSEC tunnel that needs to be optimized w/ the head-end.My question is ...

Is this possible?? looking to statically NAT addresses in a 172.x.x.x to and enterprise accessible network. This is for the purpose of in-band management.  currently running: Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA...

Hi folks, Is there any document from Cisco on route scale limit (RIB & FIB) of Cisco 1841, 2811, 3825 routers? Warm Regards

Hi all,Please, I need explanation about the following:track track-number list boolean {and | or}Cisco says the command "Configures a tracked list object and enters tracking configuration mode".Example:Device(config)# track 100 list boolean andPlease,...

Hello, i'm getting an error when the system boots up: I made a mistake when configuring aaa authorization commands.  I can't make any changes while in this state.  Command authorization failed - 'AAA API' detected the 'fatal' condition 'No method ...

Hi all,We've recently introduced two 7606-S routers on our core that are handling peering sessions and we've experienced some problems with sessions not coming up/flapping.The behaviour matches a bug known, but as we're not using BGP dampening we've ...