Routing

Dears, I have ASR 903 router whose memory utilization reaches to 50% and the show process  cpu  is only 14%. I want to know where the memory is been utilized for, and is it whether this is normal for ASR router's??? I have just uploaded the suggested...

Hello! I have a problem with configuratons QoS for 1811 and 2811 routers. Not all packets are matched by service-policy. Config from 1811: class-map match-all Conference match access-group 120 policy-map Conference class Conference  priority 8000 cla...

Hi, How do i verify that  if 5 GHz cells are designed with a -67 dBm overlap Thanks

Hi, The router crashes due to below error - System returned to ROM by bus error at PC 0x25496778, address 0x26C Router crashes only once and now its working fine. It must have been the software error due to which is happened. No hardware failure or ...

Hi, I am testing a redundant DMVPN solution with spokes that have dual internet connections but also require clients behind each spoke to be able to route directly to the internet to reach any destinations not reachable via the DMVPN hubs i.e. split ...

A900-RSP2A-128 can support how many VPN tunnels ?

Hello, Could you tell me what it means when you have two routers connected to each. And the interfaces on both sides are configured with IP Addresses but you dont see the MAC address of each interface after issuing the show arp command? Thanks in adv...

Hi , i have question a Little dump one ,How multilink actually pass traffic .Is first link start sending data to second when it it full used or its kind of load balance between two links ?

we currently have a /29 ipbock with our isp.  we just ordered more ip's and have received a /28 block of ip's.  i have currently have a cisco asa 5505 using a static ip off the /29.  i am not familiar with setting up an additional subnet to work from...

Hi,   I'm new to CISCO and have read up a lot on forums and tutorials with regards to setting up a new CISCO 1941 router.   However, I have two issues that are still unresolved:   1) Hairpinning (allowing our mail server 192.168.1.200 to be accessed ...

cisco 3945 router rebooted  dual power supply is OK SYSLOG  I don't know that reson R219_New#sh logSyslog logging: enabled (0 messages dropped, 20 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled) No Active Message Dis...

This may be a change in IOS XE vs the old IOS. Previously had 3945 routers setup with a Policy Map, using an Access-list to match services for QoS.  I could do a 'show access-lists' and it would show the number of hits on the ACL where QoS was appli...

A customer of mine has purchased a number of Meraki switches for various purposes, which I am tasked with deploying. I've found the documentation to be woefully inadequate, and completely glaze over quite important points, and I was wondering how oth...