Routing

Hi I have a Cisco ASA 5515X running version 9.5, I have a /29 public range already configured and working, i now have a /28 which the ISP have supplied in addition to the /29 The /29 is presented via a WAN router on int1, the /28 is presented on int3...

Hi I have a Cisco ASA 5515X running version 9.5, I have a /29 public range already configured and working, i now have a /28 which the ISP have supplied in addition to the /29 The /29 is presented via a WAN router on int1, the /28 is presented on int3...

Hi All I need to design a new multicast solution on my network where I have decided to run Pim Sparse mode , but some part of the network interfaces are already configured with pim sparse-dense mode, so will there be any issues if some of my interfac...

Hi,We have an ASR1004 with ASR1000-ESP20 which keeps on rebooting: Router#*Jan 13 01:09:02.020: %ASR1000_OIR-6-ONLINECARD: Card (fp) online in slot F0*Jan 13 01:09:16.649: %CPPHA-7-START: F0: cpp_ha:  CPP 0 preparing image /tmp/sw/fp/0/0/fp/mount/usr...

Hi all, Stupid question, but if the company has its own IPv4 PI space (/17 originally obtained from RIPE), is it possible to break that up and advertise, for example, a /24 from that block from a number of locations worldwide? So, for example, take...

Hi All, We already configured logging. but while show logging command or monitor . its now showing any log message. OUTPUT: show logging Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns, xml disabled, fil...

Hi Guys, is it possible to create MPLS TE over WAN MPLS transparently  if you don't have any access to the WAN backend ? What challanges do you see ? Thanks

Please see the proposed configuration.  Need help with understanding if this will work as I think it will. Situation is that the head end 3850 (Version 03.06.04) has dual 250m connections to a VPLS circuit The remote sites (5) have dual 50m circuits ...

Hello there, I want to set up the following network using a 3560 L3 switch: Have 2 different ISPs come into a L3 3560 (running adv IP services) which will be connected to FW.  The FW will then connect to a L3 LAN switch for inter-vlan routing.  All ...

 does anyone have an idea how i can enable the new EHWIC-3G-HSPA+7 cards to use PPP and not SLIP. 

I'm trying to make sure I understand exactly how an ASBR sets the forwarding address on a Type 7 LSA, and am not quite putting the final pieces of the puzzle together.  I have a router, R7 that is redistributing EIGRP routes into an OSPF NSSA area.  ...