Routing

Hi, Need advise for the below mentioned requirement. Cisco router : 18xx Lan network : 10.54.21.0/24 Primary & 10.54.74.128/26 secondary configured on a SVI interface of the router VLAN2.. Need to ensure that the Primary subnet 10.54.21.0/24 should p...

Dear All, There is always one thing in my mind, how to limit bandwidth internet traffic (download / ingress traffic), at the same times, there is a IPSEC traffic (using same internet) with direction ingress too. Can I use rate limit? Where should I p...

Hi all, I'm very new to all this. In fact, this is my first class ever in routing. As you can probably guess, I'm loving it, but as much as I'm loving it, I'm also hitting many bumps. I have a lab due and I need to design an ACL that blocks Telnet a...

Guys, I need your urgent help please. I just disconnected myself from my Boss's router at home once I issued the debug all command. The router is a home-based router 800 series and nobody's home, so I didn't expect that if I issued that command I ge...

Please assist.  Practicing a lab by creating a small network dhcp.  I am able to ping my router from my pc but cannot get past the router and ping let's say "google.com"  What would I be missing or why can I not get out into the internet?

hello, i need some guidance regarding BGP. i have taken public pool of /22. I have sub netted /22 pool in :  /24, /24, /24, /26, /26, /26, /27, /28, /28. so if i advertise /22, will i able to ping or access any of devices with above sub netted netwo...

Hi Friends Which term is correct ? Equal Cost Load Balancing on OSPF  OR Equal Cost Load Sharing on OSPF or Equal Cost Multipath Load Balancing on OSPF  I want to achieve Equal Cost Load Balancing (What is this actually?) over OSPF which will also...

Hi,I have the following configuration for a RT translation but seems not working: ip extcommunity-list standard RT-TRANSLATION-IN permit rt 2:200 route-map RM-RT-TRANSLATION-IN permit 10 match extcommunity RT-TRANSLATION-IN set extcommunity rt 2:202 ...

Hi, We have 2901 which has been in use for a while (before I came on board). They had a few different WAN links (Fiber, Cable Modem, ADSL etc.) so the configuration has been/is a bit complicated. Now we have 2 lines:      20 Mb Ethernet of Fiber  (Gi...

Hi.  I've been trying to ping port Se0/0/0 on Router 2 from either stations, but has ended in numerous failed attempts. Attached is a screenshot, really don't know how to upload my .pkt file. Thanks.

I am making trunk port in already configured switch. port 21/ 23/24 are already trunk ports, I am making 22 as a trunk port,by following commands, #int Gi1/0/22#switchport trunk encapsulation dot1q#switchport mode trunk#endBut issue is that for the t...