When trying to telnet to a 6500 switch I receive 3 user name prompts then the session closes outbefore I can type in my login credentials. This just started happening on 2 switches yesterday. Anyhelp would be greatly appreciated. Thanks
Hello All There is a dedicated SFP port on a Cisco 4331 GE0/0/2 .If I add the copper SFP module can I use it as a normal RJ 45 port .Please confirm as I need 3 RJ45 ports on my Cisco 4331 One dedictated RJ 45 port is there One combo port so I can use...
Hi Experts, Searching for whether "Is this possible to have multiple interface with same VIP on same Router". I am not finding this anywhere. Requiring this for our HA/Traffic shifting to be work perfectly. If requested feature is not available...Pls...
We keep receiving the below error in the switch log regarding multicast. We have auto rp discovery configured. Not sure why the switch is not finding the correct RP. This is happening on a feeww of our 6500 switches. Any help would be greatly aprpeci...
When would you want to do things like change OSPF cost, bandwidth, maximum paths, perform summarization, and load balance? Hope that's not a loaded question.
We have a little problem, with an RV-215-W router with the connection speed of the 3G/4G backup.We use a HUAWEI E3276 4G/LTE USB modem in Austria, the network coverage is availagbe for 4G, but the router just uses 3G/UMTS on the modem. The firmware i...
Good morning, I'm here new one but having I think simple problem with configuration on my cisco 1941 router. I need to open ports for some server in my network but I do not have efficient knowledge to do that. I will appreciate for any help solving m...
Hello,Below is the scenario; can you please help me.Rtr A gig0/0 --> gig0/0 Rtr B gig0/1 --> Rtr C gig0/1( --> denotes physically connected)Rtr B has a trunk interface to Rtr A & C and allowing all vlans (including 70)Rtr C has gi0/1.70 with encap d...
I have been having trouble doing something that should be incredibly simple, and now that it has proven difficult, it's a puzzle waiting to be solved.The ISP has given us a few static addresses to use. We have a Cisco 2800 series router / firewall d...
I am trying to add an isolated guest network to my router/ap. I was able to trunk vlan 1 at the AP but I am unable to get a dhcp address or ping the router with a manual address from SSID 'tmp' on vlan100 RouterLAR#sh runBuilding configuration... Cur...
Hi, Cisco mostly describe spine leaf design when they are talking about ACI (N9K). I would like to use a spine leaf design on the N9K series in NX-OS mode. Is this supported? Are there reference networks/design that describes this spine leaf design i...
For the RV082 this router have two wan interfaces so can i aggregate the bandwidth between two ISP connection or i can only make load balancing between them ?
Hi,I have a problem with STP, switch (SG300-28) unable to correctly set Root Bridge ID and all the time thinking that he is primary switch in the networkThe problem occurs only when the switches are connected via wifi. (this is requirement - two ante...
Hello All, Please help me with this issue I am having. I am helping a friend to setup his 1941 Cisco router and everything works well however after 12 to 14 hours we have to reset the router because it hangs, I know it is down beacuse the cameras and...
