Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

An AS owns a /20. He advertises the /20 in BGP to ispA and ispB through policies of his own decision (but he definitely advertises the prefix, and the prefix is propagated). Within the /20 is a /24, which at times he wishes to advertise via ispC. isp...

Dear All As we know, the edge router in client side gets default route from ISP' edge router. Where does the default route come from in ISP? If the ISP edge router has full route table, it produces there. If not, it comes from its upstream router unt...

yangfrank by Level 1
  • 578 Views
  • 4 replies
  • 0 Helpful votes

Current config: Port 0 is outside (VLAN 2 - going to ISP) and Ports 1-7 are inside (VLAN 1 - going to internal LAN devices). The ASA version was upgraded to 8.3.1 a few months back and everything is working properly. However, we are now wanting to ad...

hi, Could you please help me on the below issue? We have seen that sometimes few switch is reaching to waring thresold (58 Degree).My point is that can we confiure the thresold limit ? Has the switch any internal protection to avoid overload on hardw...

Resolved! BGP with two ISP

Dear All,I am trying to achieve below scenario, need your expert suggestions and help. I have two Sites A and BSite-A (Head Office, Datacenter)Subnets at Site A = A.A.A.0/24, B.B.B.0/24, C.C.C.0/24, D.D.D.0/24 Site-B (Remote Office)Subnets at Site B ...