Routing

Hi,We are setting up msdp peering between two RP's.We have yet to get it fully functioning but when we do "show ip msdp summary" or "show ip msdp peer",  there is a "?" for the SA.We do get logs that the peer is up.The commend we are using isRouter A...

         - FYI : https://www.cisco.com/c/en/us/support/docs/field-notices/723/fn72370.html  M.

Hi all,I would like to inerconnect two ATAs via Ethernet/Internet in order to have two telephone sets in differen locatios to call directly each other, without a provider.What parameter setup do I need?Is this possible using a couple of the VOIP mode...

Hi,I am running BGP, OSPF, and EIGRP routing protocol in EVE-NG and I need to access all my routers from my local desktopwhat could be the route configuration? I can be able to ping from my desktop R120 and further I can't any other routes.I have att...

I am trying to run a failover setup where i have 2 isp's century link and comcast. My issue is that I have 5 static ip's with comcast but I am unable to put the comcast router into bridge mode. I have the following 70.x.x.65 -70.x.x.69 as my usable i...

Backup router log is showing isdn activities occurred on today and yesterday, while last time main link flapped occurred on Sep 17thSep 18 03:19:40.219 CET: %ISDN-6-LAYER2UP: Layer 2 for Interface BR0, TEI 68 changed to upSep 18 03:19:54.934 CET: %IS...

Hi all,I have a DMVPN network with ISR4331 routers and wanted to do packet capture on LAN interface on one of the spokes. Unfortunately I get only ingress packets on that interface; pings go through but I can only see ping responses, not requests. Is...

Dear All,On the Catalyst L3 Switch Software (CAT9K IOSXE) I needed to install a vlan.I discovered the issue because of the configuration of the client, which prevents me from adding the vlan. As a result, I changed the mode to transparent but am unsu...

Hello,   Is it possible to mix different RSPs (880-TR & 880-LT-TR) in an ASR9K ?  Is there any document mentioning not mixing (I couldn't find any)?    Thank you!

Hi, i need a router with minimum 3 ethernet(routed port) on my router.. is it possible in any of 1700 series of router. if yes which router model and what card i can choose.RegardsRajeev

Bonjour Je souhaite installer dans mon système le Routeur CISCO IR1821-K9.Pouvez-vous me donnez les dimensions du bloc Alim PWR-MF4-125W-AC?Merci. 

Hello all, I do have a basic question, I am logging Cisco 800 series routers and a few are showing me R> mode, and we are required to enter by putting enable via ssh. where most of the devices are directly entering into enable mode.The challenges are...