I am trying to upgrade the rommon on a ISR4321/K9 and get the following error. TEST_NAT#upgrade rom-monitor filename flash:isr4300-rommon.162-1r.pkg allInvalid file: flash:isr4300-rommon.162-1r.pkgCisco IOS XE Software, Version 03.16.04b.S - Extend...
Hi. Trying to make an aggregated port (two 1Gb links)asr1001x <-----> juniper ex4200Juniper side reports that there are no issues (no drops or errors). But cisco port-channel shows some crazy output. asr1.core#sh int port-channel 1 Port-channel1 is u...
I recently replaced my Home modem with a Cisco 2901 Router and a va-vdsl EHWIC card and i got everything to work but then i needed a firewall so i accuired a pfsense firewall which is sitting inside my 2901 network and my 2901 gets my external isp ip...
I have a Multi-Office network setup through our ISP. The network allows us to put what ever VLANs/Traffic on the connection we want. The way it us Currently setup is we have SG500X units at each location. We Trunk the HQ Subnet (10.1.0.0/16) to eac...
Hello, I've got an issue that's been haunting me for awhile now. I had originally posted about it on another thread earlier in the month. Since it's separate from my original issue I figured I'd start a new discussion. I've got a router with two publ...
My datacenter is looking at installing a second ASR 1001 alongside our current external router and configuring HSRP, however, for administrative reasons we only have a /30 on the interface leading out to the cloud. Is there a way to make this work w...
Is it possible for routers on the same network to update each other about the network they are both connected to? Attached is a piece of question paper that I am going through for exam preparation. I think router A will not update router B about the ...
Hello All, Having trouble trying to figure out how to get VLANs to talk to each other. I have a L2 switches 3750G and a L3 switch 3750G with IP Routing enabled. I have been testing this out in Cisco Packet Tracer, but have been trying things as well ...
Hi, Which command can be used to check if the unused services are disbled or enabled? We use Cisco 2811. Thanks.
I have configured BGP aggregate addresses for RFC1918 address space on our WAN routers towards our core switches to reduce the routing tables sizes on our LAN devices. I have configured an unsuppress-map on our WAN peering to allow our local network...
hello, im looking to use a single 867's dialer interface to hopefully accomplish outbound PAT for internet access but also with some inbound port forwarding. ive tried the idea of a route map to only allow the external addresses i want for the port f...
Hi. Trying to make an aggregated port (two 1Gb links)asr1001x <-----> juniper ex4200Juniper side reports that there are no issues (no drops or errors). But cisco port-channel shows some crazy output. asr1.core#sh int port-channel 1 Port-channel1 is u...
Hello everyone i want to know that how i can find Packet or Data size of my Network ? from going to Branch office to HQ. mean i am in Branch Office and we connected through IPSEC VPN to our HQ Server.. we are connected through Broadband Internet no L...
Hello Everyonei faced situation with 1st-hop router for the MC-receiver selectively sending PIM join/prunes messages toward anycast RP via 2 equal cost p2p links toward RP. both interfaces are pim-sparse enabled, neighbourship is Ok, hellos are sent ...
