Hi, guys I found the MDIX issue on 2960x : Case 1 ( normal situation ) : CSW1-33VM06# interface GigabitEthernet1/0/24 description Connect to CSW2-33VM06 Gi1/0/23 switchport mode trunkend CSW1-33VM06#GigabitEthernet1/0/24 (gpn: 24, port-number: 24)-...
I have a WS-2960S-48FPS-L rev D0. Previously, I attempted to installed IOS upgrade 152-2.E8 using the CNA. It failed to upgrade correctly. Via the console, I attempted to erase the old IOS and install the new version via Xmodem. At some point du...
Hi Team, Is there some way to know the input/output rate of sub-interfaces?When I use "show interface fa0/0.1" , there is nothing related to traffic information. Many thanks. router#sh int fa 0/0 | i put rate 5 minute input rate 4000 bits/sec, 8 pa...
Hi, folks So, imagine a server connected to a switch port whose MTU is 9000 BYTES. Then imagine the traffic has to get routed and sent out a routed interface (an interface with an IP address applied) whose MTU is set for 1500. I am wondering what ...
Hi in switch4500, "show ip arp" can show mac and ip address, which are user PC's ip address. Do we have a command which tells which is static ip address or dynamic ip address? Thanks
I'm having a problem with DHCP on a Cisco RV325 router that I'm hoping someone from Cisco can help solve. I recently replaced an RV042 router with the RV325. Here's some information about our network. This router is at a remote office and gets it's...
I have a weird situation with multicast that I hope someone can shed a light on. I have a server directly connected to a 3850. It serves as command and control to several clients. For my test, one of the clients is directly connected to the 3850 ...
Hello all, We just purchased 2 Nexus 3000, and we have to connect them to Nexus 5000. My question is : is it possible ?? Is it possible to make a vPC on both side as shown in the diagram below : I saw this kind of architecture between 7000 and 500...
Cisco 3650 Stackport1 Hello everyone: I have a question: I have some switches 3650 that are reporting there stackports #1 as down in our monitoring system , but they are not stack switches, how can I get those interfaces not reporting that ...
hi everyone there are many methods to make load balance on ether-channel like dst-mac , src-mac , .. etc my question here : if i have internet service from one side , and the users from other side , if i depended on dst-mac ( mac of each user ) fr...
Hello! We have started moving all of our DHCP servers onto a 6509-E Catalyst, but do not wish for X.X.X.0 and X.X.X.255 addresses to be handed out due to the lack of communicability that clients have with it. I acknowledge that it is a great tool f...
Hi all, I had a question about SPANNING traffic to a router. I am aware that a router interface doesn't support SPAN, however I'm trying to figure out a way to forward SPAN traffic to a router. I am aware that the router has switch cards, but will ...
Hi guys, I am planning to install 2 mGig modules (WS-X4748-12X48U+E) on a 4507+E chassis. Can it support 2 of these mGig modules ? Is there a limitation on how many can be installed on each chassis type for example 4510+E?
Hi all, I am looking for some Cisco switch model suggestion for my core switch model We are building a site with 12 access switches using 10 Gig uplink and also have few servers that are not supported to 10 Gig as of now, Could you please sugges...
