With plain macsec, you can apply an MKA policy with a replay window setting, however I haven't been able to find a way to configure the replay window size for macsec setup by "cts manual". We need a replay window according to TAC to work around a s...
Hi everyone,i have a doubt in command transport preferred.What is the function of this command.since the command Transport input and Transport output doing the same thing,then why the command Transport preferred is needed.
hi ,ihave a question ,basic onfigure below ,can hosts ping others ??regards
Hi Team, Currently we are getting the below error continuously in the cisco 2960x switch. Need your inputs and solutions how to fix this error. IOS running : 15.29(2r)E1 hulc_sfp_iic_intf_read_eeprom sfp _index 2 yeti_iic_read_retry failhulc_sfp...
Hello All I am facing one issue today, I have 4 switch stack(2960x). 4 ports of switch have some issue( Gi 4/0/19 to 4/0/22) Issue is like below. When login, and check the status of these ports . it shows UP. But physical LED of that port is down and...
I want to know the command that can check the hash value on the Cisco Nexus 9516 device.
Switch Model -WS-C3850-12S-S I am using a third party SFP port Connector device to connect the FO cable to switch . Problem is Whenever the Switch i powered off ,the Port gets disabled and i have to Enable it manually Every time .
Hi Team, I have a query regarding connectivity to a router with a layer 3 switch. I want to configure a L3 switch( Catalyst 2960x switch) with different Vlans with ip routing enabled. Also i want to that switch with a Cisco 2911 Router...
My 2 Catalyst 6506-E go on Rommon and boot up any Ios image. This is the crashinfo collected: cisco WS-C6506-E (R7000) processor (revision 1.2) with 458720K/65536K bytes of memory.Processor board ID SAL1428MUNZSR71000 CPU at 600Mhz, Implementation ...
Hello, I am trying to limit a user's view of the 'show running-config' command to only those interfaces assigned to VLAN 10 i.e only ports assigned 'switchport access vlan 10' or trunk interfaces supporting VLAN 10. Is there any single command I use ...
Hi Team, Recently we have purchased the GLC-TE SFP from the Cisco team.We tried to connect those SFP's not working in our Cisco nexus switch but the same we have few old GLC-TE SFP tested on the same port its working so no issue in the switch port ...
Hello, I am trying to make a redundant practice. I can ping the server 172.16.0.10 from my host. The active switch L3 is SW-ISP-1 and the standby SW-ISP-2. If i down the interface fa0/2 the SW-ISP-2 will be the active. Here all is very good and when...
I want to config vrf,but i found two config methods: vrf definition xxxx ip vrf forwarding xxxx what's the difference between vrf definition and ip vrf forwarding ? Device info: WS-C3750X-48 (c3750e-universalk9-mz.122-58.SE2.bin) Thanks
Hi, First time use of CUCM, seemingly trivial config refuses to save: - CUCM 12.0.1.21900-7 - user webadmin (which is in groups Standard Audit Users, Standard CCM Gateway Administration, Standard CCM Super Users) - in CUCM added 2951 Gateway - in its...
Hi, can anyone help me with this? its stuck rebooting, I already tried emergency-install but nothing: % Front-end Microcode IMG MGR: unable to program device: 0% Front-end Microcode IMG MGR: malformed microcode cacheWaiting for 120 seconds for othe...
