Switching

Hi Guys, Seeking advise on BGP issue. I have been searching for results online but to no avail. My router sits in between ISP and Customer. I have advertised a /24 to ISP and it works fine. Customer has advertised a /24 to me and it works fine too....

Architecture : 3 x 3560 switches, ipservicesk9 image, linked by fibre trunks running EIGRP ...Normal DHCP works - 4 VLANS, 1 uses fixed IP - the Server VLAN, 4 use DHCP.Normal DHCP from VLans 3 to 5 works, I've configured in two ways, in both cases I...

Hello, I am in urgent need for help recovering running-configurations in rommon mode. Cisco engineers have tried everything. I am not at location yet but will be there tomorrow. I wanted to get as many info as i can. If i dont get this running-confi...

Hi, When configuring QOS on the 3750 switch the following message is displayed when looking at the queueing configuration of an interface; Shaped queue weights (absolute) : 25 0 0 0Shared queue weights : 1 30 35 5The port bandwidth limit : 100 (Ope...

Hello, We have a scenario where we are using multiple EFPs in the same BD under the same interface, this scenario was working normally with RSP1, but when we upgraded to RSP3C we get an error that we can't create more than 1 EFP in the same BD under ...

hi, I'm very much in trouble, with routing vlans... I have 3 vlans and I do not want routing between them ( They don't have to see each other ), In addition vlans 3 and 2 must have a bandwitch, I tried to configure it but I did not succeed... And I m...

Hello if i enable root guard on global mode then it will enable only on all access ports or also it will enable trunk port? 2nd question: if i have three switches in my topology. sw1,sw2 and sw3. sw1 is root bridge. now if i want to enable root guard...

I'm building a new access layer switch on a collapsed core model, and I'm pondering what would be the best way to cable the uplinks. Most diagrams look like this: SW1 -> Core1 SW1, Core2 SW1 SW8 -> Core1 SW2, Core2 SW2 However I was intrigued to no...

I inheritied a switch from my predecessor a wsc4948. So there is only one pc, a camera switch, and finally the last connection is the connection to the the switching leading to the gateway.  Symptoms are this I can telnet into the device via the onsi...

Hello: I have a situation where I need to map DSCP values to COS on a dot1q trunk to my service provider, as the provider will only make QoS decisions based on COS dot1p instead of DSCP. The handoff port is on a 3650 switch. Ideally, I think it makes...

I have a testing environment which I am playing with to better understand vlans before I need to implement and having a few issues, hope someone could help.  Below is what I am using   Watchguard Firewall with ip address 172.168.1.1 port 1 plugs into...