when i check local area connection status, it shows a packet count in millions. i tried disabling and enabling the lan connection. as so soon as i enable the the connection, packet count is rising to lacs. . i checked multiple pc's to verify the issu...
I'm trying to connect a HP C7000 to my WS-C3850-48XS switches via trunk LACP links. All is working but when i try using PVLANS the secondary ones don't seem to work.
I have the followingVLAN 100 VLAN 200 VLAN 300 Primary 301 Community 302 Community 3...
Hello, I notice on some switches that there can be a high amount of 'Total output drops' but '0 output errors'.
Then on other switches 'output errors' includes the figures from 'Total output drops'.
is this simply due to different behaviour amongst...
Hi everyone,
Hope you are all doing well. Someone brings up this topic and I like to see if you can help and share your experience. I am sorry if I should post this in "Virtualized System" company :)
We are a small shop of running a virtual syst...
Hi all,
I have the requirement to disable the syslog rate-limiting for a special syslog message on Nexus switches. We have a management system, which tracks the syslog-events which occur, when you leave the config mode e.g.
08:46:27.126 SWITCH %VSHD-...
If I were to replace (25) 3560 switches, what Meraki model would you suggest for an enterprise environment. I'm looking for stacking switches with 48 PoE ports.
This seems like it should have been an easy fix, yet here I am. Our SNS, which we're using for authentication will randomly stop doing it's job, and users can no longer authenticate. I'm not able to reach the device at all. So upon checking the physi...
I'm a newbie, trying to setup telnet in my home lab to prepare for the CCNA exam. I've set IP on management vlan, set default gateway, configured VTY lines 0 15, set transport input to all and verified all configurations. How do I physically connec...
Hi.
We have two switches in diffrent buidling connected via fibre.
For some reason, the design states that the switches will need to be configured with Lyaer 3 connectivity and redundnuncy.
So, at on e end we have the core switch with two interfac...
Hi Team,
May I know what is this (( N3548-24P-UPG= )) part number use for .
It seem like an port license upgrade for N3548. if yes then why do we need to buy this port license for N3500 series switches.
Cisco Nexus 3524 24-Port Upgrade License
...
we have establish trunk link between two switches, at the port level, there are some commands configured:
logging event trunk status
udld port aggressive
spanning-tree guard loop
load-interval 20
can anyone explain what are the purpose of the above ...
Two Questions:
1. Does anyone know if when I perform a soft reset on the Cisco XPS-2200 it will disrupt network communications or disrupt power to connected switches, other network devices, etc., that are connected to the XPS-2200? In other words, ca...
Hello, I was wondering why the output from the 'sh inteface' command, underneath '5 minute output rate' is indented ?
Is there any specific reason for this ?
Hi.
When I log in remotely via SSH to a switch via laptop or another switch, after I enter the password connection freezes. It disconnects after 2-3 minutes.
Anyone had this issue before? Any ideas?
I cannot access this switch locally.
Thank you
