Switching

I was wondering if someone could look over this config and see if anything is missing for a simple  basic setup?  Just need the routers to access the internet (ISP uses DHCP, no static address) Also attached a diagram of my network layout. 10.1.10.0 ...

Hi guys, Could you help me with the value of the internal latency of switch Cisco Catalyst 3650 series? I refer to the model with 48 ports 10/100/1000 and I didn't find any information related of. Thank for all! Allyson

I am reading the following - http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/3se/security/configuration_guide/b_sec_3se_3850_cg/b_sec_3se_3850_cg_chapter_01010.html#ID90 Port ACL section Slightly confused as the secti...

Hi Expert team, I have some questions on wireless network design. Now we are using wave 2 Cisco 2800 series APs for wireless.  Questions are below: 1. How much will long range / Signal be accepted without any loss of data? 2. I will hang an AP in roo...

Hello everyone I am setting up the PBR in a cisco 3750. The route-map is ok, I even triggered a SLA and a track object, but the interface "ip policy" command is not being retained in running-config. The SDM profile is set up as routing already: BR-...

Hi all, We have 2 server(Ramco) in 2 different locations, Primary server replicates the data to secondary server. While replicating the data these servers consumes more bandwidth so we need to restrict the limit to 3 or 4MB. We have two different ro...

hey folks  i wanna add other module for 7600 that support 10 G traffic . now i have sup32 module with 8 G ports but i want to add other modules or slots to my  router so that i be able to use 10 G i need at least 2 ports  each one 10 G. here is inv...

Wanting to setup a test IPTV setup. I have a rasberry pi running dvblast multicasting a channel to 10.255.0.9:2000. I have two other computers connected to the C2960-LANBASE-M Version 12.2?.  Problem is when I enable igmp snooping on my vlan multic...

Hi,   i have created small topology of OSPF and EIGRP and trying to redistribute route from EIGRP to OSPF and respectively, 1 - i successfully redistribute EIGRP route into OSPF all all EIGRP route showing in OSPF data base of router 0, but when i m...

We have a large number of Cisco C897VAMG-LTE routers that we can not monitor via prime.We get Unsupportet Cisco Device. When will the support of Prime for that model. /Lasse

Dear All,I don't know where can i state my problem. I have cisco 5300xm and when connecting to it with consoleI recieve the following error : Restricted Rights LegendUse, duplication, or disclosure by the Government issubject to restrictions as set f...

Hi,Nexux 7K support 5 Fabric Modules. I would like to know that each Fabric Module support 110Gbps or 46Gbps ? On Data sheet on some area they mention maximum support is 550Gbps and also mention 230Gbps.1. Each Fabric Support 110 Gbps2. Maximum Fabri...

I upgraded to IOS Version 15.2 (4) E on a 3750-X switch stack and I can no longer access the switch via the Cisco Network Assistant (CNA) via HTTPS/SSL. I have a self signed cert and the following settings no ip http server ip http authentication aaa...

CCPE запускается, но без wizard, переустанавливал ccpe, не помогает, в чем проблема ? Что делать? Роутер cisco 861