Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

What do I have to do to assign DHCP or fixed IP addresses to my Cisco ISR 1100 router's LAN ports? Most of the configuration forums I have seen talk about setting up routers by their WAN ports, often times connecting to a switch that then devices con...

lynxnebi by Level 1
  • 1289 Views
  • 3 replies
  • 5 Helpful votes

Hi all,I have a 3850 L3 switch configured to send netflow to QRadar. Everything is working fine but recently I have seen some strange events popping up in netflow coming from this switch.Recently we have tightened security with an ACL on a VLAN inter...

Hi guys,Ok , I am studying little bit of switching technology for my day to day job requirement. May be following are very basic questions for you guys but really difficult to understand for me.How one can fine the MAC address of a cisco switch. For ...

tahir1234 by Level 1
  • 158027 Views
  • 20 replies
  • 0 Helpful votes

Hello,I have a problem with in future mixed environment with Procurve and Cisco devices. Environment looks like: Router <-> SW1 (192.168.100.1) <-> SW2 (192.168.100.2)<-> Server20 (end device with networkcard and several VLANs)I will explain the curr...

Hello,I applied the monitor capture as listed below - c4500. However, I am only able to see one-way communication, meaning only traffic leaving the source IP defined in ACL, but no incoming traffic is seen on the capture. ip access-list extended MonC...

Netmart by Level 1
  • 708 Views
  • 1 replies
  • 0 Helpful votes

Hello Everyone, I am currently encountering an issue after upgrading 2 4500X in VSS. One of the switches has boot in Rommon. After a lot of reloading, booting in Rommon, and unable to establish VSS again, I've decided to convert them back to standalo...

PECET by Level 1
  • 1366 Views
  • 5 replies
  • 0 Helpful votes