cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
168
Views
0
Helpful
2
Replies

Port-channel maintenance

Steve Coady
Level 1
Level 1

All

I have a port-channel with (2) gig interfaces.

One of the interfaces has a Fluke Gig probe INLINE

I want to add another Fluke Gig probe INLINE to the other interface. 

To not cause any issues with STP, would it be best to issue a shut on the interface I am adding Fluke probe to?

what commands specifically would be best to monitor activity?

sMc
2 Replies 2

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages wha2tsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

If both port-channel interfaces are carrying traffic, disconnecting one shouldn't have impact beyond losing some "in-flight" frames on the disconnected link.  (I.e. STP shouldn't be impacted.)

Thank you Joe

sMc
Review Cisco Networking for a $25 gift card