10-11-2014 10:59 PM - edited 03-18-2019 03:31 AM
Hello,
I have two SX80 TelePresence Devices installed on same Network. I want to make call ( IP to IP ) between two Sx80 and the Result was no call Establish between them.
Are there any configuration required to do it from my side to add to the SX80?
Note: this two SX80 WORKING stand alone ( No CUCM or MCU).
Warm Regard,
Idris
10-12-2014 12:17 AM
Log in using SSH and ping one from the other to see if they can see each other, also ensure CallSetUp Mode is set to "Direct" and set default call protocol to H.323.
/jens
Please rate replies and mark question(s) as "answered" if applicable.
10-12-2014 02:53 AM
10-12-2014 03:58 AM
Thanks a lot. Jens Didriksen. it is working fine now
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide