Unified Computing System Discussions

Hi, I'm looking information for the requirements for implement WAAS on a client's network.It will be really helpful if you could share information with me. Thanks in advance.

Hi all, I have a ucs 5108 with 4 blade servers, each blade has OS - Redhat installed, when i connect to the OS an log on via "virsh console" I configure the mgmt interface with the vlan. The issue comes when I want to connect remotely via ssh to the...

i have a ucs server that is connected to my network through a single vlan access port instead of a trunk , i need to install another cucm on another vlan for testing purposes but it will have the same ip address as my current running cucm , the probl...

Dear all, I have questions like a subyek.  We have 2 server Ucs 240 M4 , both of spesification is same. The server have 2 disk (2*600gb) and using raid 1 configuration. We already installed os (Rhel 7.2) in one of server and config everything in her...

Hi guys, Just a simple of question, i'm planning to upgrade my 4x blade servers currently installed with 128GB and plan to upgrade more RAMs for better performance. May i know what is the correct procedure to remove the blade without affecting any, s...

HiI have SCOM 2012R2 CU2.CISCO UCS MP v3.0.1 Installed.I get multiple event IDs 19908 in UCS management service log every 2 hours.In management pack events I see events number 19900. cisco UCS MP authentication failed due to invalid credentials provi...

We configured syslogs on UCSM to monitor who logs in to UCSM and monitor remote users.  We receive logs for first time login but we don't receive logs if same user logs in with another browser, basically no logs if user has active UCSM session. Also ...

Hello,  I am trying to find CLI commands and find out the way to look at  auth*, authpriv* in syslogs hosts for UCSM  NXOS. Thanks 

We installed Ubuntu 16.04 on UCS C220 M4 server, which has two USB 3.0 ports at rear. We connect USB 3.0 devices on USB 3.0 port on the server. However, lsusb shows speed of 480 only. {noformat} // lsusb -vv output on the device Bus 002 Device 003: I...