cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1398
Views
0
Helpful
3
Replies

SVI suspended - non VPC config

enable.15
Level 1
Level 1

I think I exhausted all possibilities where the fault may resides. Please note this is non vpc - vpc feature is not on. Tried bouncing the interface with no luck. What else could be the issue anybody? Thanks in advance.

 

N5K1(config)# sh int vlan 10

Vlan10 is down (suspended), line protocol is down

  Hardware is EtherSVI, address is  00de.fb12.1a7c

  Internet Address is 10.0.1.51/24

  MTU 9216 bytes, BW 1000000 Kbit, DLY 10 usec

N5K1(config-if)# sh spanning-tree vlan 10

VLAN0010

  Spanning tree enabled protocol rstp

  Root ID    Priority    32778

             Address     00de.fb12.1a7c

             This bridge is the root

             Hello Time  2  sec  Max Age 20 sec  Forward Delay 15 sec

  Bridge ID  Priority    32778  (priority 32768 sys-id-ext 10)

             Address     00de.fb12.1a7c

             Hello Time  2  sec  Max Age 20 sec  Forward Delay 15 sec

Interface        Role Sts Cost      Prio.Nbr Type

---------------- ---- --- --------- -------- --------------------------------

Eth1/1           Desg FWD 2         128.129  Edge P2p

interface Ethernet1/1

  description TO WINDOWS JUMPBOXES

  switchport access vlan 10

  spanning-tree port type edge

version 7.3(2)N1(1)

vlan 10

  vn-segment 10100

interface Vlan10

  no shutdown

  mtu 9216

  vrf member transit-l3-vni

  ip address 10.0.1.51/24

3 Replies 3

enable.15
Level 1
Level 1

Anybody?

 

Forgot to mention. these svis are part of l3vni belonging to mp-bgp evpn vxlan concept but still that shouldn't matter. Its simple l3 svi at the end of the day.

nazimkha
Level 4
Level 4

Can you post the interface nve configs ?

 

have you configured suppress ARP ?

enable.15
Level 1
Level 1

Issue was around using fabric forwarding in global but svi not being part of it thus suspending it.

Review Cisco Networking for a $25 gift card