VPN

Hello All,   I did setup L2TP/IPSEC LAC on my Cisco 1921 without Radius. Users are being assigned IP address from IP Local address pool. Is it possible to have the IP addresses fixed? By fixed I mean user 'A' gets always the same 10.0.0.2 IP, user 'B...

Hello,   I've successfully configured remote access to multiple internal subnets by using NAT0 statements between the remote subnet and the internal subnets.  But I'm unable to determine the configuration that that is allowing access to our a storage...

Hi,   I found a Cisco recommendation  dated March 2015 that suggests not to run a GETVPN GM or KS on a CSR1000V. The GM I can understand, the KS less so. Does anyone know if this is still the current position ?  Many thanks.  

Dear All  I have ASA5510 Software Version 7.2, I configure Remote VPN for 2 users. I need to know how to set a role to allow each user to access one IP in my network?    Example:  User ABC should only access the IP 192.168.1.10 when he connects to my...

Hello, I recently upgraded an old ASA 5505 unit to an ASA 5506 to take advantage of the gigabit interfaces. Some of the configuration from the 5505 transferred to the 5506 with no issues. The site-to-site VPNs work as expected. I can also connect to ...

Dear all, I have a issue with a vpn between ASA and Fortigate fw. The VPN is up correctly but i am unable to ping the inside ip address at remote peer (fortigate). From fortigate the external vendor has leave a continuaty ping also but he not receive...

Pulling my hair out on this one. I think it is something fairly simple but damned if I can see it. Site to Site VPN, IPSec, Cisco 881 to a Watchguard. On the Cisco end, the tunnel is up, phase 1 and 2 active, I can see packets being decrypted but non...

Hi all I am trying to configure ipse tunnel to remote site (ASA5505) from a ISR router 4331 with source NAT. The IPSEC part alone is working, but when I add source NAT functionality, it won´t work. Here is my config: Any help would be appreciated! ! ...