04-08-2024 10:06 PM
hello there,
AP registers with WLC but unable to turn on the radios, so, ssid is not showing. but works well with POE injector. given the command "power inline static max 30000" in switch(9300 PA) as well but not working. cdp and lldp are disabled as per organisation security policy.
what went wrong?
Solved! Go to Solution.
04-09-2024 02:25 AM - edited 04-09-2024 02:26 AM
The only workaround is to use Power injectors so add that to your CAPEX.
In order to enable LLDP (vendor agnostic standard) or CDP (Cisco proprietary protocol that may not work with other vendors) do "lldp run" or "cdp run", or limit that by interface by entering "lldp transmit" AND "lldp receive", OR "cdp enable"
04-08-2024 11:57 PM
You should advice your internal security policers about thow PoE+ negotiation works on devices via CDP or LLDP-Med. When legacy Cisco APs (IOS-AP and APx800 series) do not have enough power they behave weirdly like not bringing up radios, or disconnecting clients, or not allowing clients to connect, or SSIDs dissapearing, ...
https://documentation.meraki.com/MS/Other_Topics/Troubleshooting_PoE_on_MS_switches
https://documentation.meraki.com/MR/Other_Topics/Low_Power_Mode_on_Cisco_Switches
https://www.arubanetworks.com/techdocs/ArubaOS_73_Web_Help/Content/mas_guides/lldp/PoE_Over_LLDP.htm
04-09-2024 12:02 AM
So, it is mandatory to run either CDP or LLDP in switch, and there is no workaround? if it is so, then what are the config to be added to the switch in global mode and interface wise. first we have to try and test and then only we can raise the issue as an exception.
04-09-2024 02:25 AM - edited 04-09-2024 02:26 AM
The only workaround is to use Power injectors so add that to your CAPEX.
In order to enable LLDP (vendor agnostic standard) or CDP (Cisco proprietary protocol that may not work with other vendors) do "lldp run" or "cdp run", or limit that by interface by entering "lldp transmit" AND "lldp receive", OR "cdp enable"
04-09-2024 02:30 AM
Thanks JpavonM,
will try to go with this solution and revert back.
04-23-2024 01:16 AM
Thanks JpavonM,
Your recommendation worked, tried in one of the same model switch with cdp enabled in both global and interface mode. but sadly "power inline static max 30000" didn't worked.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide