Hi, I have a Cisco 3500 AP in the Autonomous mode with 15.3.3-JE.I would like to skip the guest user authentication and display only the web page disclaimer option for Guest.There is an option called web pass from GUI and its working.How can I add a ...
when I rehost the license it says "the selceted sku L-MSE-PAK L-WIPS-ELM-1AP are not eligible for rehost "what should I do to rehost the license ?Regards,
Hi, I am setting up a cmxproxy in order for my WLC to work with CMX cloud but then I tried to follow the document provided by cisco on how to add member by using the command: [cmxadmin@CMX ~]$[cmxadmin@CMX ~]$ proxyctl members addUsage: proxyctl [O...
We have two mesh access point AP1562E with AIR-ANT5114P2M-N attached each one.We use a WLC 5520 release 8.4.100.0.
The RAP AP register without problems. The MAP AP can not. This MAP and RAP AP they was added to the WLC5520 as Local AP first and then ...
Hello experts, I have to upgrade 2 WLC's 5508 in SSO with some local AP's and some Flexconnect AP's in other countries and with a minimum of downtime. The thing is we want to control the reboot of the AP's on the remote sites.Here is how I would like...
Hi.I want to buy two wlc 5508 or two 5520.please help me if i want to use these WLCs in HA mode how to ordering(Part numbers) for Devices & Licenses.So i don't know that must buy APs License for one of wlc or for both.please help me with a sample ord...
Hello colleagues, WLC 5508 / 2504 8.3.112 PI 3.2 SNMPv3 AuthPriv I haven't found any way to restrict the SNMPv3 communication with an ACL that points to NMS/32. However, it's possible for SNMPv2c via config snmp community ipaddr ip-address ip-mask na...
Just curious if anyone know or can point me in the right direction to the reasons why the controller would admin down it's management port. I added a second Controller to my enviroment and created a mobilty group for the two and for some reason the n...
I want to disable B and G, but not N (2.4) yet.On the controller, Wireless / 80211b/g/n / Network, I can disable/enable "80211b/g Network status", will that disable the whole 2.4 radio, N also ?If so, is there any other way of doing this, or should I...
We have just purchaed AP2800I
When we plug it in we are getting:
Discovery Request sent to 255.255.25[12/19/2016 01:13:16.3400] device capwap0 entered promiscuous mode5.255 with discovery type set to CAPWAP_DISCOVERY_TYPE_UNKNOWN(0[12/19/2016 01:...
Hi All, I have a problem. Between the 1600/2600/3600 and 1700/2700/3700 generation of AP's, Cisco appears to have changed some of the regulatory domains-to-country-code mappings. My WLC is set to operate in -A and -N regulatory domains, and we have ...
Just lately my Virtual WLC keeps reboting its self. Sometimes it will last 40 mins sometimes a few hours then it will restart. Anybody else having this issue?
As part of our PCI compliance, we need to alert and detect ROGUE AP's that have been purposely or inadvertently connected to our Corpotate network. I'd like to "tune out" ROGUE AP's which have zero clients connected to it? I know there is a conditio...
